Carbide burrs are tools useful for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They feature precision, and may double in cutting, shaping, grinding and chamfering hard materials.
Carbide burrs may be used on a number of materials including metals (including Steel aluminum and cast iron) and all types of wood. Technology-not only on acrylics, fiberglass and plastics too. Carbide burrs may last for quite a while without chipping or breaking to ensure it’s so great to utilize them on soft metals like gold,platinum and silver.
Do you know the Benefits of Carbide Burrs Compared with HSS Burrs?
In contrast to HSS, Carbide Burrs less complicated harder.
The Tungsten Carbide is incredibly hard to be able to provide in wider variety of work than HSS (Very fast Steel).
HSS can’t be as good as carbide burrs if they’re at temperature. Carbide Burrs can bear hotness which enable it to run for longer time.
Carbide won’t soften at warm but HSS burrs is opposite. There’s no question that carbide is the perfect choice.
Using Carbide Burs:
To get more stability, insert the accessory bit to the tool and then back it slightly before tightening down the collet nut or keyless chuck.
Do not use these for drilling holes or enlarging holes that are below twice the diameter from the cutter. The tungsten carbide surface can certainly catch the side of a hole and break the part.
Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to avoid melting at contact point).
Start in a lower speed. Then increase to the speed that gives one of the most favourable results.
Don’t apply excessive pressure. It can slow down the spindle and chip cutting edges. Just let the bur perform the cutting.
Use the sides with the cutter for effective cutting. The top cuts poorly which enable it to break under time limits.
Never in-capsulate the bur inside the cut. If chattering occurs, increase speed.
When using aluminium and magnesium, consider some form of lubricant, wax or tallow, since it might help prevent the flutes from loading or packing.
Carbide burs, if used the right way, will outperform HSS burs by 50
To read more about SD-51 Carbide Burrs you can check the best resource