Among the first things the do-it-yourselfer realizes while studying building a drywall ceiling is that no man is definitely an island – unless he uses rented equipment! Since the panels are big, bulky, and awkward, hanging drywall on the ceiling entails one or the other: the assistance of someone else or renting a drywall jack from the local home improvement center. The cable mechanism on drywall jacks isn’t tough to operate, and jacks do an excellent job of holding the drywall within a secure, flat position making it possible to more easily attach it towards the ceiling.
Tools & Materials
How to build a Ceiling Drywall Installation includes being aware of what all tools and material you will want. As well as either someone else to help you or perhaps a drywall jack, you’ll also have to have a hammer, a drill which has a screwdriver bit, and nails or screws for drywall. You’ll also, needless to say, have to measure your ceiling (twice!) and get enough drywall, including a little extra in the event of mistakes, to do the job.
Mark Joists First
Get the boards – usually 2x4s or 2x6s – that serve as ceiling joists by tapping along the wall studs which has a hammer and following up the wall towards the ceiling. As part of finding out how to make a drywall ceiling, mark where these boards are situated which has a pencil. They’re what you will be attaching the drywall to and marking them beforehand makes it better to see them than searching for them as you are nailing or screwing about the drywall. You then have to measure in which the permanent fixture goes on the drywall and eliminate an opening to accommodate that portion of the ceiling.
The Tough Part
Its part in mastering building a drywall ceiling where you will want each other (who hopefully has a lot of stamina in addition to strength!) to carry the drywall up to the ceiling or place the drywall panel about the jack. Placed the end from the sheet of drywall – using its finished side facing down – at the center from the ceiling board (joist) to which you will nail it. Nail around the outside the panel of a less than an inch from the edges to prevent the drywall from splitting or cracking. The person who is holding the panel can now move or, should you be by using a jack, you can move it out of how.
Make It Pretty
Countersink nails or screws at six- or seven-inch intervals all along the whole joist to which the drywall has been attached. Countersinking permits you to cover up the heads from the nails/screws with compound to ensure once you paint, the heads will not whatsoever visible. Although not a legitimate portion of knowing how to construct a drywall ceiling, finding out how to cover up ugly nail or screw heads serves its own purpose for overall general carpentry knowledge.
For more details about Ceiling Drywall Installation check our resource: look at here